BubbleStop Syringe Heaters

Description

Bubbles in perfusion systems are caused by solution temperature changes. As solutions warm, they cannot hold as much gas, so they off-gas. This forms bubbles in perfusion tubing. It is especially true in inline heaters where the temperature rises dramatically. The best cure for bubbles is to pre-warm your solutions. AutoMate Scientific introduces the BubbleStop™ Syringe Heater with integrated temperature sensor and feedback. Set the temperature on the BubbleStop a few degrees higher than room temperature or your inline heater, and the warmed solutions will off-gas in the syringe reservoirs to the maximum gas concentration for that temperature. Even if they cool and re-heat again inside the perfusion tubing, they will not off-gas.

• Easy to remove full syringes
• Analog heating power – low noise for electrophysiology
• Completely shielded electronics plus external power supply
• Spill-proof design
• Range: ambient to 50°C liquid temperature
• Mounts to standard 1/2″ rod
• Includes syringes and stopcocks

Choose your options above for a complete description.

Manufacturer: AutoMate Scientific
Catalog numbers: 10-8-60-G, 10-8-60-P, 10-4-60-G, 10-4-60-P, 10-8-35-G, 10-8-35-P, 10-4-35-G, 10-4-35-P
Parent Category: BubbleStop Syringe Warmer
Application: Temperature Control

For full web page, please see https://www.autom8.com/temperature-control-overview/bubblestop-syringe-heater

Download a brochure at https://www.autom8.com/wp-content/uploads/2016/07/BubbleStop.pdf